Mesa de carregamento de corte automático de vidro

É usado principalmente para carregamento automático de vidro. Depois de colocar o vidro na posição designada e dar o sinal de carregamento, o braço grande gira cerca de 95 graus por meio do mecanismo de tombamento e toda a máquina começa a se mover para frente. Quando o dispositivo de indução no braço pequeno toca o vidro, toda a máquina para de andar e o vidro é sugado pela ventosa através do sistema de vácuo no vidro, o motor de elevação do braço pequeno levanta o vidro para cima e para trás cerca de 80 mm. O motor ambulante recua e o braço grande cai. Quando o braço de trazer está no lugar, a ventosa sob o vidro começa a soprar. Quando o braço pequeno cai, o vidro cai na roda do transportador. Finalmente, o vidro é transportado para a mesa de corte pela roda transportadora.

Alimentação de vidro totalmente automática, cortando e quebrando a linha de conexão

The whole working process can be accomplished by PLC automatic control or manual control. The manual mode is mainly suitable for equipment adjustment and maintenance.

Each action can be completed independently or can be used for normal work.After giving the loading signal (manual and automatic), the arm turns upward about 95 degrees through the overturning mechanism, and the whole machine starts to move forward.

When the induction device on the arm touches the glass, the whole machine stops walking.The vacuum system works, the glass is sucked by the sucker through vacuum systems. When the vacuum pressure reaches the set pressure, the vacuum pump stops. The sucker's telescopic connecting rod mechanism lifts the glass back and up 80 mm through the arm-lifting motor.

Stopping for about 1.5 seconds to make sure the glass is sucked up, the big arm driven by a motor to reverse the glass to the transmission roller. The suction cup under the glass begins to blow, and the telescopic connecting rod mechanism makes the suction cup and the glass fall at the same time.

When the glass falls on the conveyor roller, the small arm continues to fall, the glass is separated from the suction cup, and the conveyor starts to send the glass sheet to the front end of the loading machine and stop at the signal point.Then the whole frame moves automatically to find the zero position and stops.

Waiting for the signal from the cutting table, the glass can be sent to the cutting table at the same speed as the conveyor belt on the cutting machine. After the glass is sent out,automatically repeat the work cycle. The machine can select any position according to the required glass thickness.